Closet Materials and why did I choose them?
I’ve been asked this question about a thousand times so I thought a special post was in order!
Why did I build half the closet out of MDF and the other half out of Plywood?
First, MDF is my first choice of material for painted cabinets. It’s smooth and straight and doesn’t warp (unless you get it wet) and paints beautifully. But, IT IS STINKIN’ HEAVY! I had to lift and carry all the pieces of MDF and then after I built the cabinets, I had to lift the cabinet up to stand it on end. That was too much. So, after building the first half of my closet, my back MADE me make a change. 🙂
(The reason I didn’t switch after just a few cabinets is because I cut the pieces for ALL the cabinets on the first side at one time before I started building.)
The plywood I chose, I would not recommend and will never use for any nice cabinets again. Workshop, fine. House, no! It was cheap and smooth on one side so I got it but some of the sheets were warped which I didn’t realize until after I had them home and was cutting them so I just pushed forward but it was a pain!
It’s Sanded Plywood…which is Pine…which is soft. It’s got a smooth knot free veneer on one side and the other side is knotty and rough which didn’t matter in this situation as none of the outsides are visible in the end.
Plywood is MUCH lighter than MDF so it’s a good choice for LARGE cabinets. I usually choose a cabinet grade plywood like Birch which has a nice, hard, smooth veneer on both sides. Birch Plywood is about $45 per sheet so it’s esssspensive! Which is why I went with the Sanded Ply!
So that’s why I switched from MDF to Plywood halfway through the closet. And, if you didn’t see all my status update photos, you would be none the wiser!
I used MDF for half my closet and the closet rods have held fine. I guess it depends on how much weight you put each rod.
I know this post is super old, but I have been obsessed and am ready to start my project. Question is, I want to use MDF, but I’m concerned about MDF not holding screws well enough to hold the weight of the hanging rods. Is that an issue? I was planning to use 3/4″ for the closet.
I used some from Glideright. They were soft close but a lot of the mechanisms have stopped working. I’ve started using Blum glides as they are SO much easier to install. I have several tutorials for those.
Hello, what type of drawer slides did you use? I’m having a hard time choosing one and also intimated by making these but for my reassurance i really want to know which ones you used.
thank you.
Hi Sandra – great videos and comments, I think you answered all my concerns for the time being.
I just wanted to make a comment. I’m in the same boat as Amy and was planning to take an IKEA PAX system and simply cut it down to size to make it work for my closet needs. I can already tell I’m going to spend far more on materials going with IKEA at least for the cabinet framing and shelving. In my opinion that extra money is better spent on getting the right wood working tools which I can reuse for future projects in and around the house such as trim work.
Amy – I suggest you simply price out a 4×8 sheet of MDF or plywood vs. the PAX cabinet alone, you’ll find PAX far more expensive. I believe you will save only save on time cutting and making shelving pin holes going with PAX, not $$$.
-V D