Bathroom Vanity Progress

I’ve been building tons of cabinets for the jack and jill bathroom . The bathroom vanity is five cabinets joined together into one giant beast. Hoisting that up onto the base by myself was a chore. Especially since I’m still not back to 100% good health. My respiratory virus has somehow developed into asthma. At least it wasn’t pneumonia!

Building a Bathroom vanity

Anyway… My baseboards are 5 1/4″ tall so I’m building my cabinet bases out of 2×6’s. I built around the toe-kick vent.

I’m installing the floors later so they’ll end up covering 3/4″ of the toekick so I added 3/4″ scrap wood on top of my 2×6 base so I could lift the vent up enough to not have the floor cover part of the vent grille. Sometimes I catch things and plan ahead. Sometimes I don’t and then have to figure out how to make it work — later when I find that I didn’t plan well. We’ll see it all turns out after the floors are in. I think it will.

I designed my sink cabinets and built one of them to test out with the sink before I built the second one.

Installing bathroom vanity

I want my farmhouse sink to sit above the countertop which is not what you typically see. Normally, you see farmhouse sinks sitting flush or below the countertop. Being able to try things out and change my mind at any point is what I love about being 100% in control of my projects. I sometimes visualize something in my head but don’t like it when I see the actual reality. In this case, I like it as much in reality as I did in my head so I’m going for it.

I built the second sink cabinet and set them in place to determine their exact placement. I went back and forth here. Getting the dimensions just right is super important. If I moved the sinks too far apart or too close together, even by 1″, it changed the look and feel of the whole configuration. (The rest of the configuration was just in my head at this point but these two cabinets were enough for me to get the visual realization I needed to progress.)
The bathroom vanity side cabinets are only 12″ wide and are attached with pocket hole screws to the side of the sink cabinets. (I didn’t originally use that approach but ended up taking apart the first ones I built and going this route. Watch the video updates if you want further explanation on that. Explaining my poor planning mistakes makes me tired and upset so I’ve already moved on and forgot the reasoning. Kinda.)

I cut the holes for the pipes and drains. I actually did this before I decided I needed to raise the base with the 3/4″ scrap wood so I had to cut the holes bigger in the end and it ended up looking very sloppy and poorly planned. So I don’t want to talk about that any more. 😀

The center section is simply a bottom, two back cleats and one top cleat, attached to the two sink cabinets with pocket hole screws.

Attaching the center section created one large vanity cabinet which filled the entire width of the room. I had to climb over the vanity about 12 times to complete the task. I needed clamps to pull everything together. Then I needed flush trim pliers to cut a rogue nail… It was fun.