Quick and Easy Way to Paint Beadboard
It can be a real paint to Paint Beadboard because of all the nooks and crannies. I used to start out by painting the grooves with a brush and then using a roller to get the rest of the panel. But it takes a long time to brush EVERY SINGLE groove on a 4×8 Beadboard Panel so I took out a step.
How to paint beadboard
First, I almost always paint beadboard paneling before I cut it to size and install it. I find it’s much easier to get paint into the grooves while it’s laying flat on a work surface than after it’s installed and you have to “jab” the paint into the grooves at the bottom where it meets the baseboard or whatever it’s sitting on.
Before I start paint beadboard, I prep the panel by brushing all the dust out of all the grooves. I bought this soft bristle brush specifically for this purpose but a large dry paint brush works great too.
*I do not use an air compressor to blow the dust off. It would just settle back down on my wet paint after creating a whole room full of dusty air.
Next I Prep my roller so I don’t leave any fuzz in my paint.
Then I soak my roller to get as much paint as possible onto the beadboard panel. I push hard enough that the roller doesn’t “roll”, it slides, pushing paint along inside the groove.
Then I roll back over that area to smooth out the finish and make sure everything is covered. It might feel odd and like you’re doing it all wrong…but it’s pretty effective and fast. I don’t worry about the lines created on the roller by pushing hard, they disappear after rolling back and forth a couple times when it comes time to actually roll.
*It’s important to work in sections for this part to keep a wet edge! Smoosh some paint into the grooves in a small section and then roll it out…and then move onto the next area. Otherwise, you may end up with ridges and excess paint in some areas because you were concentrating on the paint in the grooves and not focused on where else the paint ended up.
Then I can cut and install. If applying beadboard to cabinets, I generally glue it on instead of nailing it so I don’t have any chips or nail holes to fill and touch up!
Did you find this tip helpful? You might also like these other Painting Tips!
A roller that has a very deep nap will paint right into the grooves. I painted wood paneling in my craft room which is awful because it has a horizontal texture within the vertical grooves, and I just painted it with the large nap roller then went over it with a normal one very quickly to even out the texture. It worked like a dream.
“I do not use an air compressor to blow the dust off. It would just settle back down on my wet paint after creating a whole room full of dusty air.”
Ha ha ha! After this weekend I KNOW dusty air!
I L-O-V-E Bead board! Thank you for sharing!
Kate, I buy it at Home Depot in 4×8 sheets for around $20. It comes in pine or primed MDF. I love that it’s a true Beaded board, not just a V-Groove panel. I can generally find packages of 7″ wide by 8′ lengths at Lowe’s too which can be more convenient if you are doing a small project. For beadboard wainscoting, I like the 4′ widths so I don’t have as many seams.
Good to know! I usually use a foam brush down the grooves first and then the roller but only after it is applied to the wall. Did that on most of our basement. Now I know better!
Where have you found to be the best place to buy beadboard? What brand? I have had a hard time finding sheets that look good.